Login to UI

Introduction

The following steps will guide you to login and get started with TIBCO Project Air UI.

Prerequisites

Prerequisite 1: TIBCO Cloud™ Account

Sign up for a TIBCO Cloud™ Account

• TIBCO Cloud™ Account

Prerequisite 2: Activate TIBCO Cloud™ Account

Check your email and activate your account

Prerequisite 3: Make sure TIBCO Project Air UI is running

Login Steps

Step 1: Open TIBCO Project Air UI web page

Open TIBCO Project AIR™ UI by clicking the link below:

• TIBCO Project AIR™ UI

Step 2: Enter your TIBCO Cloud™ Account credentials

Step 3: Once you are in, click the Get started button.

Step 4: You are ready to manage your devices.

All edge gateways connected to the AIR infrastructure should be displayed automatically. Note that gateways are auto registered by default.

If no gateways are running or are not enabled for auto registration, then an empty list of device groups should be displayed.

Step 3: Verify connection to Edgex Gateways

You can verify the connection to the edge gateways by clicking an entry under Device Groups table on the top-left corner panel and then click Ping Gateway. If the connection is succesful, you should see a Success banner. Otherwise, a Failure banner is displayed and you should review that Edgex is running or make sure the Address and Access Token parameters are correct.